Introductory Information Commissioning - Viessmann VITOTRONIC 200 Operating Instructions Manual

Introductory information
Commissioning
The commissioning and matching up of the heat pump
control unit to local conditions and to the structural
characteristics of the building, plus the instruction of
the user in operating the system, must be carried out
by your heating contractor.
Terminology
To provide you with a better understanding of the func-
tions of your Vitotronic control unit some terminology is
explained.
The terms are marked as follows:
Your system is preset at the factory
Your heating system is preset at the factory and is
therefore ready for operation:
Central heating/Central cooling
Your home will be heated from 00:00 to 24:00 h to
■
20 °C "Set room temperature" (standard room tem-
perature).
If a heating water buffer cylinder is installed, it will be
■
heated.
Any electric booster heater installed will be enabled
■
(see chapter "Enabling electric booster heater").
Active cooling mode is blocked (see chapter "Ena-
■
bling and blocking active cooling mode").
DHW heating
The DHW is heated every day from 00:00 to 24:00 h
■
to 50 °C "Set DHW temperature".
Any installed DHW circulation pump is switched off.
■
Any electric booster heater installed will be enabled
■
(see chapter "Enabling electric booster heater").
Frost protection
Frost protection for your heat pump, DHW cylinder
■
and any heating water buffer cylinder that may be
installed is ensured.
Note
At temperatures below
the heat pump, the DHW cylinder and the heating
water buffer cylinder is only ensured if an instantane-
ous heating water heater is installed (on site).
6
15 °C, the frost protection of
−
Note
These operating instructions also describe functions
that are only available on some heat pump models or
only with accessories. These functions are not specifi-
cally identified.
For questions relating to the extent of functions and
accessories for your heat pump and your heating sys-
tem, check with your local heating contractor.
Further information can be found in chapter
"Terminology" in the appendix.
Domestic ventilation with Vitovent 300-F
From 00:00 to 24:00 h: Domestic ventilation in oper-
■
ating status "Standard".
Wintertime/summertime changeover
This changeover is automatic.
■
Date and time
The date and time were set by your heating contrac-
■
tor.
Your heating contractor can make further settings for
you during commissioning.
You can change the settings to suit your requirements
at any time.
Power failure
In the case of a power failure, all settings are retained.