Switching Off Central Heating/Central Cooling - Viessmann VITOTRONIC 200 Operating Instructions Manual

Switching off central heating/central cooling

For the priority heating/cooling circuit
Standard menu
1. / for the operating program:
"Only DHW" (no central heating/central cooling)
■
or
"Standby mode" (frost protection is active)
■
2. OK to confirm.
For all heating/cooling circuits
Advanced menu
1.
2. "Heating" or "Heating/cooling"
Comfort function "Party mode"
Setting "Party mode" for heating/cooling
Extended menu
1.
2. "Heating" or "Heating/cooling"
3. If necessary, / for the required heating/cooling cir-
cuit.
Note
"Party mode" cannot be set for a separate cooling
circuit.
4. "Party mode"
5. Set the required room temperature for "Party
mode".
Party mode
23 °C
Change with
Fig. 18
Note
In conjunction with a ventilation unit:
Set the room temperature for ventilation up to 4 °C
lower than the room temperature for "Party mode".
This will ensure that the bypass functions correctly.
Ending "Party mode"
Automatically after 8 hours.
■
or
Automatically on changeover to the "Standard" or
■
"Fixd value" operating status, depending on the
time program.
or
Set "Party mode" to "OFF".
■
HC1
(
Central heating/central cooling
3. If necessary, press / for the required heating/cool-
ing circuit.
4. "Operating program"
5. "Only DHW" (no central heating/central cooling)
■
or
"Standby mode" (frost protection is active)
■
Display in the standard menu
21°C
14°C
Flow temperature
Fig. 19
Note
The display of the set room temperature does not
change.
The rooms are heated or cooled to the required tem-
■
perature.
If your heating contractor has not made alternative
■
adjustments, DHW is first heated to the selected
DHW temperature, before central heating/central
cooling commences.
The DHW circulation pump (if installed) is switched
■
on.
HC1
40°C
23