Dhw Heating Dhw Temperatures - Viessmann VITOTRONIC 200 Operating Instructions Manual

DHW heating
DHW temperatures
Setting the standard DHW temperature
Factory setting: 50 °C
Extended menu
1.
2. "DHW"
Setting the higher DHW temperature
Factory setting: 60 °C
The DHW will be heated to the higher DHW tempera-
ture under the following circumstances:
In the time program for DHW heating, you have set a
■
time phase for operating status "Temp. 2" (see
page 26).
You have enabled once-only DHW heating (see
■
page 28).
You have enabled manual mode (see page 43).
■
Operating program
Further information can be found in chapter
"Terminology" in the appendix.
Setting the operating program for DHW heating
For the preferred heating/cooling circuit
Standard menu
1. / for the operating program:
For example "Only DHW".
For further possible operating programs, see
page 14.
2. OK to confirm.
For all heating/cooling circuits
Extended menu
1.
2. "Heating" or "Heating/cooling"
Time program
Further information can be found in chapter
"Terminology" in the appendix.
Setting the time program for DHW heating
Factory setting: One time phase from 00:00 to 24:00 h
for every day of the week with the operating status
"Top".
26
3. "Set DHW temperature"
4. Set the required value.
Extended menu
1.
2. "DHW"
3. "Set DHW temperature 2"
4. Set the required value.
Note
Where necessary, enable the electric booster heater in
order to achieve the required DHW temperature (see
page 29).
3. If necessary, / for the required heating/cooling cir-
cuit.
4. "Operating program"
5. For example "Only DHW".
For further possible operating programs, see
page 14.
Extended menu:
1.
2. "DHW"