Standard Menu - Viessmann VITOTRONIC 200 Operating Instructions Manual

Programming unit
Preheater bank for the ventilation unit is active, if
2
installed. Symbol using fan stage 2 as an exam-
ple
Ventilation unit was switched off at the ON/OFF
switch

Standard menu

In the standard menu, you can make and call up the
following settings for the preferred heating/cooling cir-
cuit ( ):
D
Set room temperature
■
Operating program
■
A
21°C
14°C
B
C
Flow temperature
Fig. 5
Operating program for the preferred heating/cool-
A
ing circuit ( )
D
Current outside temperature
B
Set room temperature for the preferred heating/
C
cooling circuit ( )
D
Preferred heating/cooling circuit (see page 38)
D
Not shown if only one heating/cooling circuit is
installed.
Note
In the case of special system versions, the standard
■
menu may differ from the display shown here (see
chapter "Special system versions", page 44).
The settings for the preferred heating/cooling circuit
■
can also be made in the extended menu (see
page 12).
The settings for any other connected heating/cooling
■
circuits can only be made in the extended menu.
The settings for ventilation (if installed) can only be
■
made in the extended menu.
Your heating contractor can block the operation of
■
the standard menu. In such cases, you will not be
able to make adjustments either in the standard
menu or in the extended menu (see page 47).
(cont.)
D
HC1
40°C
Messages:
Fault
Warning
Note
How to call up the standard menu:
If the screen saver is active (see page 12):
■
Press OK.
If you are in the extended menu (see page 12):
■
Keep pressing the
appears.
Setting the standard room temperature for the pri-
ority heating/cooling circuit
Press the following keys:
/ for the required value.
OK to confirm.
Setting the operating program for the priority heat-
ing/cooling circuit
Press the following keys:
/ for the required operating program.
OK to confirm.
About the controls
button until the standard menu
11