System - Viessmann VITOTRONIC 200 Operating Instructions Manual

Restoring factory settings
System setting

"System"

"DHW"
"Electr booster heater"
"Heating circuit 1", "Heating circuit
2" or "Heating circuit 3"
"Cooling"
"Ventilation"
"Photovoltaics"
(cont.)
Settings and values that are reset
Time program for the heating water buffer cylinder.
■
Electric booster heater is blocked for central heating.
■
Time program for electric booster heater.
■
Standard set DHW temperature.
■
Higher set DHW temperature.
■
Time program for DHW heating.
■
Time program for DHW circulation pump.
■
Electric booster heater is enabled for DHW heating.
■
Start and stop optimisation are switched off.
■
Electric booster heater is blocked for central heating.
■
Time program for electric booster heater.
■
Set room temperature: 20 °C.
■
Reduced set room temperature.
■
Time program for central heating.
■
Heating curve slope and level.
■
Comfort and energy saving functions ("Party mode", "Economy
■
mode", "Holiday program") are deleted.
Note
If the heating/cooling circuits have been named (see chapter "Setting
names for heating circuits"), the allocated name is retained.
Set room temperature.
■
Cooling curve slope and level.
■
Active cooling mode is blocked.
■
Time program for ventilation.
■
Comfort and energy saving functions ("Intensive operation", "Econ-
■
omy mode", "Holiday program") are deleted.
Own consumption of power is switched off for all components.
■
Further adjustments
39