Flash Hook Event; Direct Call Pickup; Call Rejection Phone Numbers; Call Control [Line 1]-[Line X] - Panasonic KX-UT123 Administrator's Manual

4.6.2 Call Control [Line 1]–[Line x]

Flash Hook Event

Description
Value Range
Default Value
Configuration File Reference

Direct Call Pickup

Description
Value Range
Default Value
Configuration File Reference

4.6.1.2 Call Rejection Phone Numbers

1–30
Description
Value Range
Default Value
4.6.2 Call Control [Line 1]–[Line x]
This screen allows you to configure various call features that are specific to each line. The number of lines
available varies depending on the phone being used, as follows:
•
KX-UT113/KX-UT123: 1–2
126 Administrator Guide
Specifies the type of signal sent when sending a flash hook event.
•
Signal
•
flashhook
Signal
FLASHHOOK_CONTENT_TYPE (Page 245)
Specifies the feature number assigned to a BLF for performing call
pickup.
Max. 4 characters (consisting of 0–9, *, and #)
Not stored.
NUM_PLAN_PICKUP_DIRECT (Page 208)
Specifies the phone numbers to reject incoming calls from. A maximum
of 30 phone numbers can be specified.
Note
•
You can also configure this setting through the phone user
interface. If these settings are changed through the phone user
interface while being changed through the Web user interface,
the settings made through the phone user interface will be
overwritten by the settings made through the Web user
interface.
Max. 32 characters
Note
•
Even if you specify nonconsecutive fields (e.g., fields 1, 5, and
30), they will be rearranged into consecutive fields after you
save the settings (i.e., 1, 2, and 3).
•
If the phone number contains characters other than 0–9, *, #,
and +, the number may not be rejected correctly.
Not stored.
Document Version 2013-03