Tone Timings; Busy Tone; Tone Frequencies - Panasonic KX-UT123 Administrator's Manual

Value Range
Default Value
Configuration File Reference

Tone Timings

Description
Value Range
Default Value
Configuration File Reference

4.6.4.2 Busy Tone

Tone Frequencies

Description
Value Range
Default Value
Configuration File Reference
Document Version 2013-03
0, 200–2000 (0: No tone)
Note
•
If the value for this setting is "350,440", the unit will use a mixed
signal of a 350 Hz tone and a 440 Hz tone.
350,440
DIAL_TONE1_FRQ (Page 211)
Specifies the pattern, in milliseconds, of dial tones using up to 10 whole
numbers (off 1, on 1, off 2, on 2...) separated by commas.
Note
•
The unit will not play the tone for the duration of the first value,
play it for the duration of the second value, stop it for the
duration of the third value, play it again for the duration of the
fourth value, and so on. The whole sequence will then repeat.
For example, if the value for this setting is "100,100,100,0", the
unit will not play the tone for 100 ms, play it for 100 ms, stop it
for 100 ms, and then play it continuously.
•
It is recommended that you set a value of 60 milliseconds or
more for the first value (off 1).
0–16000 (0: Infinite time)
Note
•
Avoid setting 1–50 for any of the values.
60,0
DIAL_TONE1_TIMING (Page 212)
Specifies the dual-tone frequencies, in hertz, of busy tones using 2
whole numbers separated by a comma.
0, 200–2000 (0: No tone)
480,620
BUSY_TONE_FRQ (Page 214)
4.6.4 Tone Settings
Administrator Guide 137