Panasonic KX-UT123 Administrator's Manual page 37

The pre-provisioning process
Step 1
Connect the unit to the network, and turn the power
on. The unit is assigned an IP address by the DHCP
server, and also receives the TFTP server address
from the DHCP server using DHCP server option
66.
Step 2
The unit downloads the configuration file for
pre-provisioning from the TFTP server:
tftp://192.168.0.130/KX-UT248.cfg
Note
•
The file name may be different depending
on the phone being used. For example, the
file name for KX-UT113 users will be:
tftp://192.168.0.130/KX-UT113.cfg
Step 3
The URL of the server where the configuration file
for provisioning is stored (provisioning server) is set
to the unit:
http://provisioning.example.com/Panasonic/
Config{MAC}.cfg
Step 4
The unit will display a message indicating
pre-provisioning is complete.
Step 5
When the message is displayed, turn off the unit's
power, then turn it back on.
The unit may restart automatically depending on the
configuration file programming (® see
"OPTION66_REBOOT" in 5.3.5 Provisioning
Settings).
When the unit is distributed to end users and started
up in real circumstances, provisioning will be
performed correctly.
Note
•
This example describes the case when only one unit is connected. However, multiple units can be
configured through the same procedure without changing any settings, because the MAC address is
specified by the {MAC} macro.
Document Version 2013-03
2.1.4 Pre-provisioning Setting Example
Power on
TFTP Address
SIP Phone
192.168.0.130
tftp://192.168.0.130/
KX-UT248.cfg
SIP Phone
http://provisioning.example.com/
Panasonic/Config0080F0123456.cfg
SIP Phone
"Complete Pre-Provisioning"
SIP Phone
http://provisioning.example.com/
Panasonic/Config0080F0123456.cfg
Config0080F0123456.cfg
SIP Phone
DHCP Server
Option 66
TFTP Server
KX-UT248.cfg
Provisioning
Server
Administrator Guide 37