Lldp-Med Settings; Lldp_Enable; Lldp_Interval; Lldp_Vlan_Id_Pc - Panasonic KX-UT123 Administrator's Manual

5.4.9 LLDP-MED Settings

Value Range
Default Value
5.4.9 LLDP-MED Settings

LLDP_ENABLE

Value Format
Description
Value Range
Default Value

LLDP_INTERVAL

Value Format
Description
Value Range
Default Value

LLDP_VLAN_ID_PC

Value Format
Description
Value Range
Default Value
204 Administrator Guide
0–3
–
0: Enable "Basic Network Settings" and "Time Adjust Settings"
–
1: Disable "Basic Network Settings"
–
2: Disable "Time Adjust Settings"
–
3: Disable "Basic Network Settings" and "Time Adjust Settings"
0
Integer
Selects whether to enable or disable sending and receiving LLDP
frames.
Note
•
This setting is available only when "NW_SETTING_ENABLE" is
set to "N".
•
You should specify "Y" for only one of "LLDP_ENABLE",
"VLAN_ENABLE", or "IEEE8021X_ENABLE".
If "Y" is specified for two or more of the parameters above, the
settings are prioritized as follows: IEEE8021X_ENABLE >
VLAN_ENABLE > LLDP_ENABLE. Therefore, if "Y" is specified
for both "VLAN_ENABLE" and "LLDP_ENABLE", the
VLAN-related settings are used.
•
Y: Enable
•
N: Disable
Y
Integer
Specifies the interval, in seconds, between sending each LLDP frame.
1–3600
30
Integer
Specifies the VLAN ID for the PC port when LLDP is on.
0–4094
0
Document Version 2013-03