Leds; Installation Options; Power Conservation; Mac Address Table - Allied Telesis AT-x230-10GP Installation Manual

LEDs

Here is a brief description of the port LEDs:
Installation
The switches can be installed in the following ways:
Options
Power
The switches implement Eco-Switch Green Power saving features and
use less power than the METI specification. The switches have the
Conservation
following power conservation features:
MAC Address
Here are the basic features of the MAC address table:
Table
AT-x230-10GP, AT-x230-18GP and AT-230-28GP Switches Installation Guide
POWER and FAULT LEDs; refer to "Power and Fault LEDs" on

page 25.
Link/Activity/Speed/PoE LEDs for the twisted pair ports; see "10/

1000BASE-T/100BASE-TX Link/Activity/Speed LED and PoE
Status LED" on page 27.
Link/Activity LEDs for the SFP slots; see "SFP LEDs" on page 30.

SD card LED: refer to "SD card LED" on page 31.

Note
The ecofriendly button turns off the LEDs (excluding the POWER
LED and SD card LED) to conserve electricity. See "Ecofriendly
button" on page 33.
Rack mounted in a 19-inch equipment rack

Mounted on a desk or tabletop

Wall mounted

ecofriendly button to turn off the port LEDs when the system is not

being monitored
High efficiency power supply

Power scaling based on traffic loads on ports operating at

1000Mbps (port power scaling not available at 10 or 100Mbps)
Power shutdown on unused ports

Storage capacity up to 16K MAC address entries

Automatic learning and aging

7