Installing An At-X230-18Gp Switch In An Equipment Rack; Figure 20: Attaching Rack Mount Brackets To The At-X230-18Gp Switch - Allied Telesis AT-x230-10GP Installation Manual

Installing an AT-x230-18GP switch in an equipment rack

AT-x230-10GP, AT-x230-18GP and AT-x230-28GP Switches Installation Guide
These instructions show you how to install an AT-x230-18GP switch in an
equipment rack. Rack mount kits for the AT-x230-18GP switch, AT-RKMT-
J13, can be purchased separately from your Allied Telesis dealer.
To install an AT-x230-18GP switch in a 19-inch equipment rack, follow
these steps:
1. If rubber feet are attached to the base of the switch, remove them
(Figure 17).
2. Attach two rack mount brackets to the sides of the switch using the six
bracket screws that come with the rack mount kit AT-RKMT-J13
(Figure 20).
F 20. A
IGURE TTACHING RACK MOUNT BRACKETS TO THE
SWITCH
AT- 230-18GP
X
49