Installing An At-X230-28Gp Switch In An Equipment Rack; Figure 22: Attaching Rack Mount Brackets To The At-X230-28Gp Switch - Allied Telesis AT-x230-10GP Installation Manual

Installing an AT-x230-28GP switch in an equipment rack

AT-x230-10GP, AT-x230-18GP and AT-x230-28GP Switches Installation Guide
These instructions show you how to install an AT-x230-28GP switch in an
equipment rack. A rack mount kit is included with your AT-x230-28GP
switch.
To install an AT-x230-28GP switch in a 19-inch equipment rack, follow
these steps:
1. If rubber feet are attached to the base of the switch, remove them
(Figure 17).
2. Attach two rack mount brackets to the sides of the switch using the six
provided bracket screws (Figure 20).
F 22. A
IGURE TTACHING RACK MOUNT BRACKETS TO THE
SWITCH
AT- 230-28GP
X
51