Canon ImageRunner 2545i Reference Manual page 84

IMPORTANT
Make sure that the paper size setting is correct. If the paper size loaded on the stack
bypass and the paper size setting do not match, a paper jam may occur.
NOTE
• If you make a mistake when entering numbers, press [C] (Clear) ➞ enter the
correct numbers.
• When entering numbers in millimeters, you can also use
and (Clear) on the control panel.
• To enter values in inches, press [Inch]. (See "Entering Values in Inches," on
p. 3-7.)
• When entering the length in inches, an underbar (_) must be entered between
integer and fraction.
• You can press [Size 1] or [Size 2] to specify the paper size if the values for the
horizontal and vertical axes are registered beforehand. (See "Registering
Nonstandard Paper Sizes," on p. 3-21.)
❑
Press [X] ➞ enter the length along the
horizontal axis of the paper using the
numeric keys.
The horizontal length can be set
between 148 mm and 432 mm.
❑
Press [Y] ➞ enter the length along the
vertical axis of the paper using the
numeric keys.
The vertical length can be set between
99 mm and 297 mm.
❑
Press [OK].
-
❑
Press [Next].
Specifying Common Settings
3
(numeric keys)
3-19