Canon ImageRunner 2545i Reference Manual page 186

# 0703
Cause The memory for image data is full when sending color documents.
Remedy 1 Wait for a few moments and try again after other send jobs are complete.
Remedy 2 Delete documents stored in memory. If the machine still does not operate
normally, turn the main power OFF and then back ON.
# 0705
Cause The send operation was interrupted because the size of the image data is larger
than that specified in <Maximum TX Data Size> in E-mail/I-Fax Settings.
Remedy 1 Change the setting for <Maximum TX Data Size> in E-mail/I-Fax Settings. (See
Chapter 4, "Setting the Send Function," in the System Settings Guide.)
Remedy 2 Select a lower resolution. (See Chapter 3, "Specifying the Scan Settings," in the
Sending and Facsimile Guide.)
Remedy 3 If you are using I-fax, decrease the number of pages containing images that you
are sending each time, so that you do not exceed the data size limit specified in
<Maximum TX Data Size>.
Remedy 4 Set Divide into Pages to 'On' on the File Format screen. (See Chapter 3,
"Specifying the Scan Settings," in the Sending and Facsimile Guide.)
# 0749
Cause You could not execute the job because a service call message is being
displayed.
Remedy Restart the machine. (See "Restarting the Machine," on p. 6-63.) If the machine
does not restore, turn OFF the main power switch, and disconnect the power
cord from the power outlet. Then, contact your local authorized Canon dealer.
# 0751
Cause 1 The file server is not functioning.
Remedy Check that the file server is operating properly.
Cause 2 The network is down (the server is unable to connect to the network or was
disconnected).
Remedy Check the network status.
Self-diagnostic Display
6
6-19