Volume Control; Setting The Audible Tones (When The Optional Super G3 Fax Board-Ag1 Is Not Attached) - Canon ImageRunner 2545i Reference Manual

Volume Control

You can customize the machine to enable or disable the audible tones produced in
the events listed in the table below. The volume of these tones can be adjusted if
the optional Super G3 Fax Board-AG1 is attached to the machine.
2
Entry Tone
Error Tone
Send (TX) Done Tone
Receive (RX) Done Tone
Print Done Tone
Scan Done Tone
Sleep Mode Tone
Feeder Set Tone
Monitor Volume (Dial tone) The machine is dialing to connect to the recipient's fax device.
NOTE
• Depending on the machine configuration, some of the above tones may not be
available.
• The default settings are '1' for Monitor Volume, 'Off' for Send Done Tone and Receive
Done Tone, and 'On' and '1' for all the other tones.
Setting the Audible Tones (When the Optional Super G3
Fax Board-AG1 Is Not Attached)
If the machine is not configured as a traditional fax machine, set the audible tones
as described below.
1
Press
2-30

Volume Control

Tone
A key is pressed on the control panel or touch panel display.
The machine encounters a trouble, such as a paper jam,
operational error, etc.
A document is sent.
A document is received.
Printing is complete.
Scanning is complete.
The machine enters or wakes from the Sleep mode.
Originals are placed in the feeder.
(Volume Control).
Sounds When...