Basler A500k User Manual page 89

You can set the area of interest using either the Camera Configuration Tool Plus (see section 4.1)
or binary commands (see section 4.2). You use the Area of Interest Starting Column, Area of
Interest Width in Columns, Area of Interest Starting Line and Area of Interest Height in Lines
commands.

Note that the binary commands start to count at 0.

In normal operation, the camera is set to use all of the pixels in the array. To use all
of the pixels, the starting column should be set to 1, the width in columns to 1280,
the starting line to 1 and the height in lines to 1024.
The setting for the width in lines and for the starting column must be divisible by 10.
The minimum width is 10.
The minimum height in lines is 2. The minimum starting line is 0.
The sum of the setting for the starting column plus the setting for the width in
columns can not exceed 1281.
The sum of the setting for the starting line plus the setting for the height in lines can
not exceed 1025.
k
Basler A500
PRELIMINARY
Basic Operation and Features
3-39