Table of Contents
Advertisement
2.10 Status LED
When the LED on the back of the camera is not lit, it means that no power is present. When the
LED is lit, it means that power to the camera is present.
Keep in mind that the circuit used to light the LED on the camera does not perform a voltage range
check. If power to the camera is present but it is out of range, the LED on the camera may be lit
but the camera will not operate properly.
When the LED on the back of the camera is orange this indicates signal integrity. At power up, the
LED will light for several seconds in orange and sometimes green as the microprocessor in the
camera boots up. If all is OK, the LED will then remain orange continuously.
If an error condition is detected at any time after the microprocessor boots up, the LED will begin
flashing an error code. See section
k
Basler A500
PRELIMINARY
6
for details.
Camera Interface
2-35
Advertisement
Table of Contents
Troubleshooting
