Revision History - Basler A500k User Manual

Revision History

Doc. ID Number
DA00057001
DA00057002
DA00057003
DA00057004
DA00057005
DA00057006
DA00057007
k
BASLER A500
Date Changes
14 Oct 2002 Initial release covering series production cameras.
07 Jan 2003 The A501
The high and low byte information was added to the AOI stamp.
The AOI Stamp and Dynamic AOI register was renamed and is now
called the AOI Feature register.
25 Jul 2003 Vibration, shock, and bump specifications were added.
FVAL high time in Figure 2-8 and Figure 2-9 was corrected.
Figure 2-5 and Table 2-6 were changed.
The flash trigger output schematics for open collector and high side
switch and explanation were added in Figure 2-4.
The explanation of exposure modes in section
The minimum AOI height in lines was changed to 2.
The responsivity of the sensor changed, and with it the explanation in
section
A power supply recommendation was added to section 2.8.
2 Dec 2004 Marked several values in Table
In section 5.3, added sensor horizontal and vertical position tolerances
referenced to the sides of the camera.
Added a Feedback section.
18 Apr 2005 Updated Figure 2-5 and Figure 2-7 in section 2.3.
Corrected flash trigger modes in section
ger mode "Always high" is 0x03 and not 0x04).
Corrected Write Command and Data Format in section
of the data bytes have been inversed).
4 April 2006 Corrected the address for Singapore in the "Contacting Basler Support"
section of the front matter.
Corrected a LED supply voltage for the low side switch in Figure 2-4.
Corrected the steps and added information about reset behavior in the
note box in section 4.2.9.
Corrected the tilt angle tolerance in Figure 5-3.
Added section
20 Mar 2007 Updated Basler address in the U.S.A.
Added storage conditions in section 1.4.
Interchanged required pixel clocks between A504k/kc and A501k/kc in
section 2.5.2.
Replaced FlashOut signal by Integrate Enabled signal in all figures of
section 3.3.
Augmented explanations in sections
Replaced "ExSync signal" by "internal control signal" in section 3.3.4.
Made minor corrections and additions throughout the manual.
Integrated the A503k.
DRAFT
color camera was added to the series.
kc
1.3 and the formulas in section 3.6.1.
1-1
6.2 that describes what to do before calling tech support.
3.3 was improved.
as typical.
4.2.4.16 (the ID for the flash trig-
4.2.10
3.3.1 to 3.3.5.
(the order
i