Alarms Menu Options And Parameters - Radyne DMD20 Installation And Operation Manual

DMD20 Universal Satellite Modem
BIT ERRORS
FREQ OFFSET (Hz)
VOLTAGES (menu)
+1.5V RX SUPPLY
+1.5V TX SUPPLY
+3.3V SUPPLY
+5V SUPPLY
+12V SUPPLY
+20V SUPPLY
-20V SUPPLY
RX BUFFER LEVEL
RX BUFFER RESET ((ENTER))

4.3.7 Alarms Menu Options and Parameters

CURRENT ALARMS (menu)
Masking alarms may cause undesirable modem performance.
TX MAJOR (menu)
FPGA CFG
DSP CFG
TM103 – Rev. 1.1
Displays the current error count from the Viterbi
Decoder.
Displays the received carrier frequency offset as
measured by the modem.
Displays the measured voltage of the 1.5 Volt Rx power
bus located inside the modem.
Displays the measured voltage of the 1.5 Volt Tx power
bus located inside the modem.
Displays the measured voltage of the +3.3 Volt power
bus located inside the modem.
Displays the measured voltage of the +5 Volt power bus
located inside the modem.
Displays the measured voltage of the +12 Volt power
bus located inside the modem.
Displays the measured voltage of the +20 Volt power
bus located inside the modem.
Displays the measured voltage of the -20 Volt power bus
located inside the modem.
{0 – 100%}
Displays the status of the Doppler Buffer.
Causes Doppler Buffer to re-center.
Status Edit Table
{Pass/Fail, Unmasked/Masked}
Indicates a transmit FPGA hardware failure.
{Pass/Fail, Unmasked/Masked}
Indicates a transmit FPGA failure.
User Interfaces
4-15