Aupc Menu Options And Parameters - Radyne DMD20 Installation And Operation Manual

User Interfaces
TX ES ENHANCED (menu)
TX ES ENHANCED
TX INTERFACE
ES BAUD RATE
ES BITS/CHAR
RX ES ENHANCED (menu)
RX ES ENHANCED
ES BAUD RATE
ES BITS/CHAR

4.3.5 AUPC Menu Options and Parameters

Note: AUPC Menus are only available when the Modulator is in 'Closed Net' Network Spec
and Framing is 'EFAUPC 1/15'.
EF AUPC (menu)
LOCAL AUPC (menu)
AUPC ENABLE
NOMINAL TX POWER
4-12
{DISABLED, ENABLED}
{RS-232, RS -485}
{150 - 19200}
Allows the user to select the baud rate in Enhanced
Async Mode. Available rates are listed in Table 3-3.
{7,8}
Allows the user to choose between 7 or 8 bit data.
{DISABLED, ENABLED}
{150 - 19200}
Allows the user to select the baud rate in Enhanced
Async Mode. Available rates are listed in Table 3-3.
{7,8}
Allows the user to choose between 7 or 8 bit data.
The 'LOCAL AUPC CONFIGURATION' Menu contains
the local configuration parameters for the AUPC
Function.
{OFF, ON}
Allows the user to enable or disable the Local AUPC
Function of the local modem. The Local AUPC Function
is the response to the commands for an increase or
decrease of the Transmit Power in 0.5 dB steps. The
command to change to the setting is indicated in the
'REMOTE CL ACTION' Menu upon receiver loss of lock
of the remote modem.
{variable through power range}
Allows the user to set the nominal Transmit Power. The
nominal Transmit Power is the setting that will be used
when the remote modem indicates that its receiver has
lost lock and commands a change to the setting
indicated in the 'REMOTE CL ACTION' Menu. That
change will only be implemented if the 'REMOTE CL
ACTION' Menu is set to "NOMINAL".
DMD20 Universal Satellite Modem
TM103 - Rev. 1.1