Radyne DMD20 Installation And Operation Manual page 146

DMD20 Universal Satellite Modem
<1> Forced Alarms
<1> Alarm1Mask
<1> Alarm2Mask
<1> Common
Alarm1Mask
<1> Common
Alarm2Mask
<11> Tx Circuit ID
<1> Tx ESC Ch1 Volume
<1> Tx ESC Ch2 Volume
<1> Tx Interface Type
<1> Tx Terrestrial
Loopback
<1> Tx Baseband
Loopback
<1> Drop Status Mask
<1> Tx RS N Code
<1> Tx RS K Code
TM105 – Rev. 1.1
(0 = None, or else a 1 in the following bits means force)
Bit 0 = Backward Alarm 1 IDR and IBS
Bit 1 = Backward Alarm 2 IDR only
Bit 2 = Backward Alarm 3 IDR only
Bit 3 = Backward Alarm 4 IDR only
Bit 4 = AIS Request
Bit 5 = Yellow Alarm. D&I Mode
Bits 6 and 7 = Spares
TBD
TBD
TBD
TBD
11 ASCII characters
-20 to +10 (+)10 dBm to –20 dBm)
-20 to +10.(+)10 dBm to –20 dBm)
0 = G703-B-T1-AMI
1 = G703-B-T1_B8ZS
2 = G703-B-E1
3 = G703-B-T2
4 = G703-U-E1
5 = G703-U-T2
6 = G703-U-E2
7 = RS-422
8 = V.35
9 = RS-232
0 = Disabled, 1 = Enabled
0 = Disabled, 1 = Enabled
Bit 0 = Frame lock mask
Bit 1 = Multiframe lock mask. Valid in E1 PCM-30 and
30C
Bit 2 = CRC lock mask. Valid in T1ESF, and E1 CRC enabled
Bit 3 = T1 yellow alarm received mask
Bit 4 = E1 FAS alarm received mask
Bit 5 = E1 MFAS alarm received mask. Not valid in FAS mode
Bit 6 = E1 CRC alarm received mask
Bit 7 = CRC calculation error
0 = Mask, 1 = Allow
2 - 255. Reed-Solomon code word length
1 - 254. Reed-Solomon message length
Appendix B
PCM-
B-7