Radyne DMD20 Installation And Operation Manual page 66

User Interfaces
T1/E1 SIGNALING
IFEC LOCK
OFEC LOCK
INTERLEAVER
RS UNCORR. WORD
COMMON (menu)
TERR FPGA CFG
CODEC FPGA CFG
CODEC DEV CFG
VOLTAGES (menu)
+1.5V RX SUPPLY Displays the measured voltage of the 1.5 Volt Rx power
+1.5V TX SUPPLY Displays the measured voltage of the 1.5 Volt Tx power
+3.3V SUPPLY
+5V SUPPLY
+12V SUPPLY
+20V SUPPLY
-20V SUPPLY
4-18
{Pass/Fail, Unmasked/Masked}
TBD
{Pass/Fail, Unmasked/Masked}
Indicates that the Framing Unit is unable to find the
expected framing pattern.
{Pass/Fail, Unmasked/Masked}
Indicates that the Reed-Solomon Decoder is not locked.
{Pass/Fail, Unmasked/Masked}
Indicates that the Reed Solomon Interleaver is not
synchronized.
{Pass/Fail, Unmasked/Masked}
Indicates that the Reed-Solomon Decoder has detected
a block that is uncorrectable.
{Pass/Fail, Unmasked/Masked}
Indicates an Interface Card FPGA hardware failure.
{Pass/Fail, Unmasked/Masked}
Indicates Turbo Codec Card FPGA hardware failure.
{Pass/Fail, Unmasked/Masked}
Indicates Turbo Codec Card ASIC hardware failure.
bus located inside the modem.
bus located inside the modem.
Displays the measured voltage of the +3.3 Volt power
bus located inside the modem.
Displays the measured voltage of the +5 Volt power bus
located inside the modem.
Displays the measured voltage of the +12 Volt power
bus located inside the modem.
Displays the measured voltage of the +20 Volt power
bus located inside the modem.
Displays the measured voltage of the -20 Volt power bus
located inside the modem.
DMD20 Universal Satellite Modem
TM103 - Rev. 1.1