Radyne DMD20 Installation And Operation Manual page 70

User Interfaces
FRONT PANEL (menu)
BKLT LEVEL
BKLT TIMEOUT
KEY SOUND
TERMINAL (menu)
TBD
REMOTE PORT (menu)
ADDRESS
BAUD RATE
INTERFACE
TCP/IP (menu)
BOOT MODE
BOOTp SERVER
4-22
{OFF, LOW, MED, HIGH}
Allows the user to enter the backlight intensity level.
{00 - 99}
Allows the user to enter the length of time (in seconds)
of keyboard inactivity before the backlight shuts off. 00
= no timeout.
{ON, OFF}
Allows the user to enable or disable the audible beep
each time a key is pressed. Illegal entries will still cause
a beep to be heard.
{32 - 255}
Allows the user to enter the Remote Port Multidrop
Address.
{150, 300, 600, 1200, 2400, 4800, 9600, 19200, 38,400}
Allows the user to enter the Remote Port Baud Rate.
{RS-232, RS -485}
Allows the user to enter the Remote Port interface type.
{DEFAULT, NON-VOL, BOOTP}
DEFAULT: If no Ethernet Interface is to be used. No IP
Address or mask changes will be allowed.
NON-VOL: Stores and uses IP Mask and addresses as
provided by the user.
BOOTP: At boot time, use Bootp Protocol to get names,
masks, and IP Addresses of the modem, router, and
server.
{128 – 257, default is 206}
Only used if Bootp is selected in Boot Mode. Should be
consistent with the tag expected by the users Bootp
Server.
DMD20 Universal Satellite Modem
TM103 - Rev. 1.1