Alarms Menu Options And Parameters - Radyne DMD15 Installation And Operation Manual

DMD15/DMD15L IBS/IDR Satellite Modem
Event Buff:
Press Clr to Erase Events:
Voltages (menu):
+5 Volt:
+12 Volt:
-12 Volt:
Buffer:
Press Clr to Center Buffer:
BER Exponent:

4.3.7 Alarms Menu Options and Parameters

Active Alrms (menu):
Masking alarms may cause undesirable modem performance.
Major Tx (menu):
TxuProc Mask:
TxPower Mask:
TxOSClk Mask:
TM051 - Rev. 5.8
Displays a history of events recorded in the event buffer.
A maximum of 40 events may be stored in the buffer.
st
Upon receipt of the 41
automatically deleted, and so on, maintaining the
maximum 40 events.
Clears the contents of the Event Buffer.
Displays the measured voltage of the +5 Volt power bus
located inside the modem.
Displays the measured voltage of the +12 Volt power bus
located inside the modem.
Displays the measured voltage of the -12 Volt power bus
located inside the modem.
Displays the status of the Doppler Buffer from 0 to 100%.
Causes Doppler Buffer to re-center.
{6 - 9}
Allows the user to set the time base for the Channel
Error Rate Measurement, used to estimate E
Status Edit Table
{Pass/Fail, No/Yes}
Indicates a Hardware Transmit or DSP Failure within the
modem.
(Yes = Masked, No = Unmasked)
{Pass/Fail, No/Yes}
Indicates that the Modem Tx Output Power is within
allowed tolerance. A solid indication indicates a
hardware or programming failure within the modem.
{Pass/Fail, No/Yes}
Indicates that the TX Oversample Clock PLL is not
locked. This alarm will flash on during certain modem
User Interfaces
event, the first received event is
/N
b
.
o
4-17