Alarms Menu Options And Parameters - Radyne DMD50 Installation And Operation Manual

DMD50 Universal Satellite Modem
-12V SUPPLY
RX BUFFER LEVEL
RX BUFFER RESET ((ENTER))

4.3.7 Alarms Menu Options and Parameters

Masking alarms may cause undesirable modem performance.
CURRENT ALARMS (menu)
TX MAJOR (menu)
FPGA CFG
DSP CFG
SCT CLOCK PLL
SYM CLOCK PLL
LB SYNTH PLL
IF SYNTH PLL
ETHERNET WAN
TM118 – Rev. 1.1
Displays the measured voltage of the -12 Volt power bus
located inside the modem.
{0 – 100%}
Displays the status of the Doppler Buffer.
Allows the user to re-center the Doppler Buffer when
<ENTER> is pressed on the keypad.
Status Edit Table
{Pass/Fail, Unmasked/Masked}
Indicates a transmit FPGA configuration failure.
{Pass/Fail, Unmasked/Masked}
Indicates a transmit DSP configuration failure.
{Pass/Fail, Unmasked/Masked}
Indicates that the Tx SCT Clock PLL is not locked. This
alarm will flash on during certain modem parameter
changes. A solid indication points toward a configuration
failure within the modem.
{Pass/Fail, Unmasked/Masked}
Indicates that the Tx Symbol Clock PLL is not locked.
This alarm will flash on during certain modem parameter
changes. A solid indication points toward a problem with
the incoming clock to the modem (SCTE).
{Pass/Fail, Unmasked/Masked}
Indicates that the Tx L-Band Synthesizer is not locked.
This alarm will flash on during certain modem parameter
changes. A solid indication points toward a configuration
problem within the modem.
{Pass/Fail, Unmasked/Masked}
Indicates that the Tx IF Synthesizer is not locked. This
alarm will flash on during certain modem parameter
changes. A solid indication points toward a configuration
problem within the modem.
{Pass/Fail, Unmasked/Masked}
User Interfaces
4-23