Table of Contents
Advertisement
DMD50 Universal Satellite Modem
JS4 STATUS
WAN STATUS
VOLTAGES (menu)
+1.5V RX SUPPLY
+1.5V TX SUPPLY
+3.3V SUPPLY
+5V SUPPLY
+12V SUPPLY
+20V SUPPLY
-12V SUPPLY
CnC (menu)
CnC DELAY
CnC FREQ OFFST
CnC RATIO
RX BUFFER LEVEL
RX BUFFER RESET ((ENTER))
4.4.6 Alarms Menu Options and Parameters
Masking alarms may cause undesirable modem performance.
CAUTION
MN-DMD50 Revision 4
{See the note above}
Displays the current status of the LAN Port.
{See the note above}
Displays the current status of the WAN Port.
Displays the measured voltage of the 1.5 Volt Rx power bus
located inside the modem.
Displays the measured voltage of the 1.5 Volt Tx power bus
located inside the modem.
Displays the measured voltage of the +3.3 Volt power bus
located inside the modem.
Displays the measured voltage of the +5 Volt power bus located
inside the modem.
Displays the measured voltage of the +12 Volt power bus located
inside the modem.
Displays the measured voltage of the +20 Volt power bus located
inside the modem.
Displays the measured voltage of the -12 Volt power bus located
inside the modem.
Routine delay (ms)
Runtime Frequency Offset (KHz) between interferer and the
desired received signal.
Power Ratio between interferer and the desired signal in dB.
{0 – 100%}
Displays the status of the Doppler Buffer.
Allows the user to re-center the Doppler Buffer when <ENTER>
is pressed on the keypad.
User Interfaces
4–22
Advertisement
Table of Contents
