Radyne DMD20 Installation And Operation Manual page 148

DMD20 Universal Satellite Modem
<2> AUPC Target Eb/No
<2> AUPC Minimum
Power
<2> AUPC Maximum
Power
<2> AUPC Nominal
Power
<1> Control Mode
<1> Revision Number
<1> Alarm1
<1> Alarm2
<1> Common Alarm1
<1> Common Alarm2
<1> Latched Alarm1
<1> Latched Common
Alarm1
<1> Latched Common
Alarm2
<1> Drop Status
<1> OnlineFlag
<1> +5V Voltage
<1> +12V Voltage
<1> -12V Voltage
<2> Temperature
<1> ESC Source
TM105 – Rev. 1.1
Target Eb/No at Receiver
Singed value +50 to –200 with implied decimal point; 49 =
+4.9 dBm
Singed value +50 to –200 with implied decimal point; 49 =
+4.9 dBm
Singed value +50 to –200 with implied decimal point; 49 =
+4.9 dBm
Status Bytes
0 = Front Panel. 1 = Terminal, 2 = Computer
Decimal point implied
TBD
TBD
TBD
TBD
TBD
TBD
TBD
Bit 0 = Frame lock fault. 1 = Fail
Bit 1 = Multiframe lock Fault. Valid in E1 PCM -30 and PCM-
30C. 1 = Fail
Bit 2 = CRC lock fault. Valid in T1ESF, and E1 CRC enabled.
1 = Fail
Bit 3 = T1 yellow alarm received. 1 = Received
Bit 4 = E1 FAS alarm received. 1 = Received
Bit 5 = E1 MFAS alarm received. Not valid in FAS mode. 1 =
Received
Bit 6 = E1 CRC alarm received. 1 = Received
Bit 7 = CRC calculation error. 1 = Fail
0 = Offline, 1 = Online
+5V. Implied decimal point. ex: 49 = +4.9 V
+12V. Implied decimal point. ex: 121 = +12.1 V
-12V. Implied decimal point and minus sign. ex: 118 = -11.8 V
Degrees C. Implied decimal point. ex: 490 = 49.0 C
0 = Internal, 1 = External
Appendix B
B-9