QUANTA W Mainboard Series S210-MBT2W Technical Manual page 210

BMC
[3.1.198] Network Settings Page (Continued)
I
TEM
This option lists the following IPv6 configuration
settings.
IPv6 Settings: This option is to enable the

IPv6 settings in the device.
Obtain an IPv6 address automatically: This

option is to dynamically configure IPv6
address using DHCP (Dynamic Host Config-
uration Protocol).
IPv6 Address: To specify a static IPv6

IPv6 Configuration
address to be configured to the device. Eg:
2004:2010
Subnet Prefix length: To specify the subnet

prefix length for the IPv6 settings.
Note:
[3.1.199] Value ranges from 0 to 128.
Default Gateway: Specify v6 default gateway

for the IPv6 settings.
D
ESCRIPTION
3-23
[3.1.198] Network Settings Page (Continued)
I
TEM
It lists the VLAN configuration settings.
VLAN Settings: To enable/disable the VLAN

support for selected interface.
VLAN ID: The Identification for VLAN config-

uration.
VLAN Configuration
Value ranges from 1 to 4095.

VLAN Priority: The priority for VLAN configu-

ration.
Value ranges from 1 to 7.

7 is the highest priority for VLAN.

Save To save the entries.
Reset To Reset the modified changes.
[3.1.200] Procedure:
3.1.201.1.Select the LAN Interface from the drop down list.
3.1.202.2.Check Enable to enable the LAN Settings.
3.1.203.3.In IPv4 Configuration, enable Use DHCP to
Obtain an IP address automatically to dynamically con-
figure IPv4 address using DHCP.
3.1.204.4.If the field is disabled, enter the IPv4 Address,
Subnet Mask and Default Gateway in the respective
fields.
3.1.205.5.In IPv6 Configuration, if you wish to enable the
IPv6 settings, check Enable.
C G
ONFIGURATION ROUP
D
ESCRIPTION