Net-Total Formulation - Sartorius LP Models Operating Instructions Manual

Net-Total Formulation R
Purpose
With this application program
you can weigh in different
components up to a defined total.
You can also print out the total
weight and the individual weights
of the components.
Available Features
– Taring
– Weighing different components
(maximum: 99 components) from
"0" to a defined total component
weight
– Storing component weights
("Store xx comp."), with
– display zeroed after value
stored, and
– automatic printout (print appli-
cation parameters);
either
– of the last component weight
(net value) or
– of the total weight (tare value)
– Display of the transaction counter
"XXth" (referring in each case
to the next component) in the soft
key label display
– Clearing of the component
memory when the weighing
series is canceled c
and printout of the total weight if
you have configured the balance
for GLP-compliant printouts;
otherwise, printout of the net
value p
– Toggling between
component weight and total
weight by pressing w.
– ISO/GLP-compliant printout
of the total of the individual
component weights (Tot.cp)
Factory Settings
Automatic printout when component
value stored: print net total (7 3 1)
40
Preparation
Turn on the balance
> All display segments
light up briefly
Select the Net Total application
in the Setup menu: Press M
Select menu:
Press the menu soft key (w)
Set parameter 2 1 6:
See "Configuring the Balance"
Exit the Setup menu:
Press M
Setting Parameters
for the Net-Total Application
k Access the Setup menu:
Select Menu
Set the parameter for automatic
printout when component stored
7 3 Print net total
See "Configuring the Balance"
Exit the Setup menu:
Press M
Additional Functions
In addition to functions for:
– alphanumeric input,
– taring
(not during alphanumeric input),
– printing,
you can also access the following
functions from this application:
– calibration
(not during alphanumeric input),
– setup,
– turning off the balance.
Calibration/Adjustment
Press q
> See "Calibration/Adjustment"
for further instructions
Setup (setting parameters)
Press M
> See "Configuring the Balance"
for further instructions
Turning Off the Balance
Press e
> The balance shuts off
> The display goes blank