Sartorius LP Models Operating Instructions Manual page 7

Separate Operation of the Display Unit
Turn the balance upside down and lay it on a padded surface
to avoid damage to the weighing system.
Use a screwdriver to remove the 2 screws from the display unit retainer
Remove the display unit
> Cable lengths
– LP balances with a weighing capacity ≤ 12 kg: 55 cm
– LP balances with a weighing capacity ≥ 16 kg: 80 cm
k See the chapter entitled "Accessories" for information on longer cables
k If you wish to use a longer cable, it must be installed by an authorized
Sartorius service technician
Options for Mounting the Display Unit for a Balance with
a Weighing Capacity ≥ 16 kg
The display unit can be mounted as follows:
– on the short side of the weighing cell (factory mounting)
– on the back (long side) of the of the weighing cell
Turn the weighing cell over
Remove the fastening screws from the display unit retainer
Remove the fastening screws from the plate that covers the cable raceway
(channel) and remove the plate
Fasten the display unit retainer onto the back of the weighing
cell with the 2 Allen screws
Thread the cable through the raceway and replace the cover plate
Getting Started
7