Clutch Installation - Honda VT600C Shadow VLX Service Manual

CLUTCH/GEARS H I FT LI N KAGE
Temporarily install the clutch outer and install the gear holder
as shown .
TOOL:
Gear holder
Install the washer and bolt and tighten the bolt.
TORQUE: 90 N • m (9.0 kg-m, 65 ft-lbl
Remove the gear holder and clutch outer.
Install the following:
- ignition pulse generators
(
- clutch page
7 - 1 2 )
• NOTE
If removed the ignition pulse generator wire grommets were
removed from the case g roove,reinstall them securely.
CLUTCH I NSTALLATION
Apply MoS2 paste grease t o t h e outside o f the clutch outer
guide and install the oil pump d rive sprocket over the outer
guide.
I nstall the oil pump d rive chain on the drive sprocket.
I nstall the oil pump driven sprocket with the " I N " mark facing
inside.
Guide the drive chain over the sprocket.
Apply locking agent to the threads of the driven sprocket
mounting bolt and tighten it with the washer to the specified
torque.
TORQUE: 1 5 N·m ( 1 . 5 kg-m, 1 1 ft-lbl
7 - 1 2
07724 - 00 1 0 1 00
'iiT oiL V
PU MP D R I EN
SPROCKET