1 ) Squeeze the brake lever, then open the bleed valve 1 /2 turn
and close the valve.
NOTE
Do not release the brake lever (or pedal) u ntil the bleed
•
valve has been closed .
2) Release the brake lever slowly and wait several seconds
after it reaches the end of its travel.
Repeat steps 1 and 2 until bubbles cease to appear i n the fluid
at the end of the hose.
Tighten the bleed valve .
TORQUE : 5 . 5 N • m ( 0 . 5 5 kg-m, 4 ft-lbl
Close the bleed valve, fill the reservoir with the specified brake
fluid to the casting ledge leve l .
Reinstal l t h e diaphragm, set plate and cover.
•
A contaminated brake disc or pad reduces stopping po wer. Dis
card contaminated pads and clean a contaminated disc with a
high quality brake degreasing agent.
BRAKE PAD/DISC
F R O N T B RA K E PAD R E PLAC E M E N T
A
contaminated brake disc or pad reduces stopping po wer. Dis
•
card contaminated pads and clean a contaminated disc with a
high quality brake degreasing agent.
NOTE
Always replace the brake pads i n pairs to assure even disc
•
pressure .
'88 , '89 , '9 1 -'93 :
Remove the pad pin plugs and loosen the pad pins.
Remove the caliper mounting bolts, then remove the brake cal
iper and bracket.
Pry one old pad agai nst the caliper with a screwdriver to push
the pistons i nto the caliper.
H Y D RAU LIC D I SC BRAKE
1 4 - 5