Honda VT600C Shadow VLX Service Manual page 172

C RAN KSHAFT/TRANSMISSION
I nstall the lock washer and stop washer, aligning bigger tabs of
the lock washer with bigger grooves of the stop washer in the
countershaft groove .
Turn the washers as shown to lock them on the nearest spline.
I nstall the stop washer first, and then the lock washer for the
C3 gear.
Align and lock the washers using the procedure above.
Assemble the countershaft and mainshaft.
Check the gears for freedom of movement or rotation on the
shaft .
Check that the snap rings are seated in the grooves and align
their end gaps with the lands of the splines.
' 8 8 , ' 89 , ' 9 1 -' 9 5 :
I nstall the left shift fork on t h e shaft with M R 1 mark facing the
groove on the shaft end and the bolt hole aligned with the
shaft hole.
' 8 8 , ' 89 , ' 9 1 -' 9 5 :
Tighten the bolt with the lock washer a n d bend up the tabs of
the lock washer.
1 1 - 1 8
I
( 2 ) LOCK WASHER
( 1 ) MR1 MARK
( 2 ) G ROOVE
( 1 ) BOLT
( 2 ) TABS
( 1 ) STOP
WASHER