Honda VT600C Shadow VLX Service Manual page 139

I nstall the carburetor insulator o n the cylinder head, aligning
the boss on the cylinder head with the slot in the insulator.
After '9 1 (Cal ifornia model only) :
I nstall the insulator bands align i n g the pins o n the insulator
bands with the slots o n the insulato rs as shown .
Tighten the band screws secu rely .
I nstall the cylinder head .
I nstall the 1 0 m m nut/washer, 8 m m nut/washer, 8 mm bolt/
washer and 6 mm bolt and tighten them in a crisscross pattern
i n 2 or 3 steps.
TORQUE :
1 0 mm nut: 4 8 N•m ( 4 . 8 kg-m, 35 ft-lb)
8 mm bolt: 23 N•m (2.3 kg·-m, 1 7 ft-lbl
8 mm nut: 23 N·m (2.3 kg-m, 1 7 ft-lbl
6 mm bolt: 1 0 N•m ( 1 .0 kg-m, 7.2 ft-lbl
'88, '89:
Check the oil pass pipe bolts and oil pass pipe for clogging or
bending.
I nstall the oil pass pipe, new sealing washers, oil pass pipe
bolts and the pipe holder bolt.
Tighten the bolts .
TORQU E :
O i l pass pipe bolt:
7 mm: 1 0 N•m ( 1 .0 kg-m, 7 . 2 ft-lb)
8 mm: 23 N • m (2.3 kg-m, 1 7 ft-lb)
CYLI N D E R H EA D IV ALVE
( 1 ) BOSS
( 3 ) 8 m m BOLTS/WASHE
( 1 ) SEALING WASH ERS
.--
( 3 ) O I L PIPE HOLDER
( 2 )
SLOT
( 2 )
9- 1 7