Honda VT600C Shadow VLX Service Manual page 111

Align the grooves in the clutch outer with the bosses on the oil
pump drive sprocket while turning the sprocket with the chain
and pushing the clutch outer onto the shaft.
Install the thrust washer onto the m a i nshaft.
I nstall the spring seat, judder sprin g and clutch disc
c l utch center.
N OTE
N ote the positions of the seat, spring and disc B.
•
I nstal l clutch discs, clutch plates, clutch disc A, the plates,
d i scs, and pressure plate on the clutch center and install them
in the clutch outer as an assembly.
8
Align the tabs in the disc
N OTE
Stack the discs and plates alternately as shown.
•
Coat the new clutch discs with clean engine oil.
•
I n stall the washer on the mainshaft .
After' 9 5 :
I n stall the spring washer o n the mainshaft with the
" O U T S I D E" mark facing o utside .
8
w ith the slots on the clutch outer.
on the
(3) DISC B
CLUTCH/G EARS H I FT L I N KAGE
J U DDER SPRING
( 2 )
( 1 ) SPR I N G SEAT
7 - 1 3