Camshaft Installation - Honda VT600C Shadow VLX Service Manual

CYLI N D ER H EAD/VALVE
I nstal l the following :
- cam chain tensioner with washers and bolts .
TORQUE: 1 0 N·m ( 1 . 0 kg-m , 7 . 2 ft-lbl
- camshaft ( page
9- 1 8 )
- camshaft holders ( page
9 - 1 9 )
- cylinder head cover (page
CAMSHAFT I NSTALLATION
Apply m o l ybdenum disulfide oil to t h e rocker arm shafts .
I nstal l the ·ocker arms, rocker arm shafts and wave washers i n
t h e camshaft holders .
NOTE
I nstal l the wave washers in the proper position as show n .
•
Position the grooves in the rocker a r m shafts vertically, align­
ing the bolt holes of the holder with the holes of the shafts .
Apply molybdenum disulfid e oil to the rocker a rm slipper faces .
F R O N T CYLI N D E R
NOTE
If the rear cylinder head has not been serviced, remove the
•
rear cylinder head cover and check the camshaft position as
follows:
Turn the crankshaft counterclockwise and align the " RT"
mark on the flywheel with the index mark on the timing
hole, then look for the identification mark on the camshaft
flange .
If the notch mark is facing up, turn the crankshaft counter­
clockwise approximately
instal l ation of t h e front camshaft.
If the notch mark faces down ( cannot be seen) , turn the
cra nkshaft cou nterclockwise
°
and beg i n insta l lation.
( 52 )
9 - 1 8
9-2 1 )
(41 2 ° )
turn and begi n
1 - 1 /8
approxi matel y turn
1 /8
( 1 CHAIN TEN SIONER
l
.,_,� 'il!lltW'
( 1 ) WAVE WASHERS
,
MoS2
( 1 ) G ROOVES