Rear Wheel Installation; Rear Brake Inspection - Honda VT600C Shadow VLX Service Manual

I nstal l the axle collar.
I N STALLAT I O N
I nstall the brake panel on the wheel hub.
Position the rear wheel between i n swingarm and install the
drive chain over the driven sprocket.
Install the left side adjuster collar onto the rear axle and insert
the axle (from the left side) through the swingarm, wheel hub
and right side collar.
I nstall the adjuster collar and axle nut.
Tighten the axle nut lightly.
Adjust the drive chain ( page
Tighten the axle nut.
TORQUE: 90 N · m (9.0 kg-m, 65 ft-lbl
Connect the brake torque rod to the brake panel with bolt, seat
washer, washer and nut. (page
Tighten the nut.
TORQUE: 27 N • m (2. 7 kg-m, 20 ft-lbl
I nstall the cotter pin and bend back it securely.
Connect the brake rod to the brake arm and adjust the rear
brake pedal free play (page
R EAR BRAK E
I N S PECT I O N
Remove t h e rear w heel (page
Remove the brake panel and measure the rear brake drum I . D.
SERVICE LIMIT: 1 6 1 mm ( 6 . 3 in)
Measure the rear brake lining thickness.
SERVICE LIMIT: 2 m m (0.08 in)
Replace the brake shoes if either one is thinner than the service
limit.
3 - 1 3 ) .
1 3-8 ) .
3 - 1 6 ) .
1 3 - 3 )
REAR WH EEL/BRAKE/S USPENSION
· --=
1 3- 7