Eneo 22X User Manual page 30

• VIEW ANGLE SETUP
FLIP: OFF, AUTO, 90, 100, 110, 120,
OFF: the dome camera moves until 90 vertically.
AUTO: When the camera reaches the floor directly above the moving object, it will stop. At
that time, release the Joystick instantly and pull it down again to run the auto-flip function.
When you use the panning range, we recommend using the flip mode to AUTO.
90, 100, 110, 120 : allows the image to flip digitally when the camera moves over the
setting angle vertically.
TILT LIMIT:
This option has been designed to limit the view angle as there is some obstruction in
zooming out on specific area of the tilt angle.
ON: When this option is enabled, the range of the tilt angle will be limited to 10 degree.
This can prevent from obstruction or bad focus problem caused by the horizontal line of
the semi sphere in the bubble.
OFF: When this option is disabled, the range of the tilt angle will not be limited.
When you zoom out within the range of the tilt angle, you will see the horizontal line of
the semi sphere in the bubble.
PANNING RANGE
When the dome camera is installed near a wall, panning range can be limited by user.
1. Place the dome camera under 90 degree vertically.
2. Set "RIGHT LIMIT" by pushing the Joystick to the right.
3. Set the left limit by pushing the Joystick to the left.
4. Set ENABLE to ON to use.
To exchange the right and the left limit, set SWAP to ON.
To apply limits on the auto pan (endless panning), set AUTO PAN to ON.
NOTE: When the flip mode is 90, 100, 110 or 120 and you moves over 90 vertically, the
panning range operates in opposite side.
VIEW ANGLE SETUP
PANNING RANGE
FLIP
TILT LIMIT
SAVE AND EXIT(ESC TO CANCEL)
PANNING RANGE SETUP
RIGHT LIMIT : 000.0
LEFT LIMIT : 000.0
ENABLE : OFF
SWAP : OFF
AUTO PAN : ON
SAVE AND EXIT(ESC TO CANCEL)
24
: 90
: OFF
(CTRL KEY)