Table of Contents
Advertisement
• INITIALIZE DATA
FACTORY DEFAULT
Select "FACTORY DEFAULT" to initialize the Data.
ERASE PROGRAMMED DATA
Erase all stored data from the Flash-ROM of the selected dome camera. You will be asked
to enter ON or OFF. If you desire to erase all data then select "ERASE" run, otherwise press
the ESC key to exit without erasing. The erased data includes all stored data (Auto Scan,
Preset, and Tour....) except origin offset.
The offset value is still valid after all data is erased. The offset value can be zero with default
set of Offset origin menu.
PRESET FOCUS DEFAULT
This menu set the default mode of the focus when you save the Preset.
FOCUS
INITIALIZE DATA
FACTORY DEFAULT
ERASE PROGRAMMED DATA
PRESET FOCUS DEFAULT
EXIT(ESC TO EXIT)
FACTORY DEFAULT
ARE YOU SURE ?
ERASE PROGRAMMED DATA
AUTO SCAN
PRESET
TOUR
PATTERN
AREA TITLE
PRIVACY ZONE
CAMERA
DOME SETUP
ERASE
SAVE AND EXIT(ESC TO CANCEL)
PRESET FOCUS DEFAULT
FOCUS
SAVE AND EXIT(ESC TO CANCEL)
: AUTO / MANUAL / ONE PUSH
CANCEL
OK
: ON
: ON
: ON
: ON
: ON
: ON
: ON
: ON
: AUTO
25
Advertisement
Table of Contents
