Auto Scan (Shortcut: Scan) - Eneo 22X User Manual

3.4 Auto Scan
The Auto Scan supports up to 5 programmed angles at user-programmable speeds. Follow
these steps to program Auto Scan:
NUMBER : 01~04, 09:AUTO PAN mode.
TITLE : up to 12 characters.
MODE : NORMAL, VECTOR, RANDOM (AUTO PAN mode: NORMAL, RANDOM only).
NORMAL : Move from start point to end point in panning only.
VECTOR : Move from start point to end point including tilt and zoom simultaneously and
linearly.
RANDOM : Move randomly between the start point and the end point.
SPEED : 01~13 step, the lower number means the slower speed.
SCAN DIR : Set the Scan direction, CCW(Counter Clock Wise), CW(Clock Wise).
SWAP : Swap the start point for the end point.
DWELL : Set the dwell time at the both end, 01~99 seconds.
1. Press the SCAN key to enter the Auto Scan menu directly. Or press the MENU key to display
the main menu on the monitor. Scroll to Auto Scan and push the Joystick to the right.
2. Select "NUMBER" and set the desired number by pushing the Joystick to the left or right.
3. Select "TITLE" and twist the Joystick to enter the title edit mode.
4. Twist the Joystick by changing the alphanumeric characters and move the next position. Or
move down to the character table and press the CTRL or IRIS Open key at the desired
character then the cursor position moves to the next position automatically. Push the Joystick
to the left or right at the "ALL DELETE" field to delete all characters. Push the Joystick to the
left or right at the "EXIT" field to finish title edit menu.
5. Select "MODE" and "SPEED".
(Shortcut: SCAN)
AUTO SCAN SETUP
NUMBER
TITLE
MODE
SPEED
START ANGLE : ----- -----
END ANGLE
SCAN DIR
SWAP
DWELL
SAVE AND EXIT(ESC TO CANCEL)
TITLE EDIT MENU
A01
*
A B C D E F G H I J
K L M N O P Q R S T
U V W X Y Z 0 1 2 3
4 5 6 7 8 9 ( )
ALL DELETE
EXIT(ESC TO EXIT)
: 01
: A01
: NORMAL
: 5 STEP
: ----- -----
: CCW
: OFF
: 03 SEC
10