Area Title - Eneo 22X User Manual

3.9 Area Title

Enter a specific name on programmed angle between START and END. For the screen below,
when the camera points at an angle between 124.3 (PAN), 30.7 (TILT) to 359.5 (PAN), 45.4
(TILT), ABC will be displayed on the screen.
NUMBER : 01-08
TITLE : up to 12 characters.
SWAP : Swap the start point for the end point.
1. Select "NUMBER" and set the desired number by pushing the Joystick to the left or right.
2. To edit the title, follow the procedure of the Auto Scan above to edit titles.
3. Select "START ANGLE". Hold down the CTRL key while selecting the start position using the
Joystick. Current panning position will be displayed. Release the CTRL key to complete the
selection of the start position. Or press the IRIS Open key then the "CTRL" displays. Move the
desired position. Press the IRIS Close key then the "CTRL" disappears. To adjust at the 0.1
degree interval, twist the Joystick at the pan field and the tilt field.
4. Select "END ANGLE". Hold down the CTRL key while moving the Joystick to select the end
position. Release the CTRL key to complete the selection of the end position. Or press the
IRIS Open key then the "CTRL" displays. Move the desired position. Press the IRIS Close key
then the "CTRL" disappears. To adjust at the 0.1 degree interval, twist the Joystick at the pan
field and the tilt field.
5. Select "SWAP". Set to ON, to exchange the start angle and the end angle.
6. Select "SAVE & EXIT" and push the Joystick to the right or press the IRIS Open key. Press
the ESC or IRIS Close key to exit the program without saving.
AREA TITLE SETUP
NUMBER : 01
TITLE : ABC
START ANGLE : 124.3
END ANGLE : 359.5
SWAP : OFF
SAVE AND EXIT(ESC TO CANCEL)
17
30.7
45.4