Table of Contents
Advertisement
1802-065-A-8-06
3.1.6
Postal Switch
This programming sequence will set how the two switch inputs on the telephone entry system control
board will operate. Switch input 1 is labeled PSW (postal switch) and is found on terminal 4 of the
main terminal strip. Switch input 2 is a two terminal auxiliary input located on the upper left hand
corner of the control board. These switch inputs can be programmed to activate their respective
relays (switch 1 - relay 1, switch 2 - relay 2). They can also be programmed so that switch 1 dials out
the phone number programmed in directory code 0, 00, 000, or 0000, and switch 2 dials out the
phone number programmed in directory code 1, 01, 001, or 0001. Each switch is programmed
independently.
Factory setting is: Switch input 1 = 0 (relay 1 activates), Switch input 2 = 0 (relay 2 activates).
1.
Press *23 and enter the four-digit MASTER CODE _ _ _ _ (beep).
2.
Press 1* (beep) to set switch 1, or press 2* (beep) to set switch 2.
3.
Press 0* (beep) to set the switch input to activate the relay, or press 1* (beep) to set
the switch input to dial-out a preprogrammed phone number.
4.
Press 0# TOGETHER to end this programming step (beeeeeep).
3.1.7
Touch-tone / Rotary-dial
This programming sequence will set the telephone entry system to dial out in either a touch-tone or
rotary format. Generally, this will be set for touch-tone.
Factory setting = 0 (touch-tone).
1.
Press *07 and enter the four digit MASTER CODE _ _ _ _ (beep).
2.
Enter 0* (beep) for touch-tone or enter 1* (beep) for rotary.
3.
Press 0# TOGETHER to end this programming step (beeeeeep).
3.1.8
Number of Rings to Answer
This programming sequence sets the number of rings to allow before the telephone entry system
answers a call placed to it. This programming sequence does not affect the number of times that a
resident's telephone will ring when a call is placed from the entry system to the resident.
Factory setting = 02 (two rings).
1.
Press *18 and enter the four-digit MASTER CODE _ _ _ _ (beep).
2.
Enter the number of rings _ _ then press * (beep).
3.
Press 0# TOGETHER to end this programming step (beeeeeep).
3.1.9
Keypad Function
This programming sequence sets the function of the 0 through 9, and the # keys on the keypad
during conversation. The keys can be set to hang-up the entry system when they are pressed during
conversation, or they can be programmed to DTMF tone out during conversation. The later may be
desirable if the entry system is used with an auto-attendant type telephone system where the caller is
prompted to enter numbers from a touch-tone telephone. HINT: If DTMF tones are required, program
the # or * key to hang-up the system.
Factory setting = 0 for all numbers (hang-up).
1.
Press *26 and enter the four-digit MASTER CODE _ _ _ _ (beep).
2.
Enter the desired key number _ then press * (beep).
3.
Press 0* (beep) for hang-up, or press 1* (beep) for touch-tone.
4.
Repeat steps 2 and 3 to program other keys.
5.
Press 0# TOGETHER to end this programming step (beeeeeep).
Page 26
Advertisement
Table of Contents
