Canon MultiPASS C5000 Service Manual page 66

Part 1: Facsimile
5.4.4 SCNT board replacement precautions
Before replacing the SCNT board, print out all of the stored data.
The reports which output the data that must be entered into the new SCNT board is listed
below.
User report
One-touch speed dialing list
Coded speed dialing list
Group dialing list
User data list
Send/Receive Activity report
Service report
System data list
System dump list
REFERENCE
A
To printout these reports, see
To PC registration function, see
The serviceable SCNT board does not have a jumper plug. This is to prevent
the lithium battery power from draining. Use the jumper plug on the old
SCNT board.
After the new SCNT board is installed and the power is turned on, " D A T A
ERROR" will be displayed. Press the START/COPY key to discard the
Refer to
Chapter 3. 3. ADJUSTMENT on Page 3-6
on duration and to adjust the vertxnl lint alignment.
Then refer to the rrport that mns printed out beforehand and enter the
various data.
Chapter
Page l-46.
1-52