Photoconductor Unit Removal - Lexmark C734dn Service Manual

5026

Photoconductor unit removal

Not a FRU
Warning: To avoid damaging the photoconductor drum, hold the photoconductor units by their handle and
place the photoconductor units on a clean surface. See
page 4-2
1. Open the front access door.
Lift the right end handle (A) of the photoconductor unit, releasing from the mount.
2.
Lift the unit up and away from the left side of printer, ensuring the left end of the photoconductor is released
3.
from the holding pin (B).
B
Installation note: If a new photoconductor unit is installed, reset the life count value in the printer memory.
If a message appears on the operator panel:
•
When 84 <color> PC Unit Life Warning or 84 Replace <color> PC Unit appears, select Supply
1.
Replaced, and then press
Replace Supply displays.
Select Cyan PC Unit, Magenta PC Unit, Yellow PC Unit, or Black PC Unit based on the
2.
photoconductor unit that was just replaced, and then press
<color> PC Unit Replaced displays.
Select Yes, and then press
3.
If no message appears:
•
Press Menu (
1.
Select Supplies Menu, and press
2.
3. Press
Select Cyan PC Unit, Magenta PC Unit, Yellow PC Unit, or Black PC Unit based on the
4.
photoconductor unit that was just replaced, and then press
<color> PC Unit Replaced displays.
Press
Service Manual
4-132
for additional information.
.
to clear the message.
).
to select Replace Supply.
to select Yes.
"Handing the photoconductor unit" on
.
.
.
Previous
Next
Go Back
A