5026
Top access cover assembly removal
See
"Top access cover assembly" on page 7-3
Warning: When replacing any one of the following components:
•
Operator panel assembly
•
System board
•
Top access cover assembly
Only replace one component at a time. Replace the required component, and perform a POR before
replacing a second component listed above. If this procedure is not followed, the printer will be
rendered inoperable.
Remove the rear frame cover. See
1.
Disconnect the cable connectors at JOPP1(A), JFMUSB1 (B), and JBIN1 (C) on the system board.
2.
Remove the right cover. See
3.
4.
Remove the fuser. See
Note: Be sure to observe the cable routing.
Service Manual
4-40
for the part number.
"Rear frame cover removal" on page
"Right cover removal" on page
"Fuser removal" on page
4-104.
4-33.
4-37.
Previous
Next
Go Back