Fuser Dc Cable Removal; Go Back - Lexmark C734dn Service Manual

5026

Fuser DC cable removal

Note: The fuser to system board autoconnect cable is red.
1. Remove the top cover assembly. See
Turn the top cover assembly over.
2.
Remove the connector (A) from the top cover assembly.
3.
Warning: You will damage the old connector in the process. Be careful not to damage the top cover
assembly.
Pull the cable through the hole (B) in the top cover assembly, and the notch (C).
4.
Service Manual
4-106
"Top cover assembly removal" on page 4-43.
Previous
Next

Go Back