203.09—Paper Jam error service check
Step
Questions / actions
Open the front access door. Turn the
1
transport belt gear clockwise.
Did the transport belt move?
Turn the printer off, and then remove the
2
fuser. See
"Fuser removal" on page
Is the exit sensor flag damaged?
Verify the paper is loaded properly in the
3
paper tray or manual feed slot.
Is the paper properly loaded?
Replace the fuser. See
4
4-104. POR the printer.
page
Did the error clear?
Go to step 2.
Replace the fuser. See
4-104.
"Fuser removal" on
page
Go to step 4.
Problem resolved.
"Fuser removal" on
Yes
Replace the transport belt.
See
removal" on page
Go to step 3.
4-104.
Load paper correctly.
Remove the new fuser, and
go to step 5.
Diagnostic information
5026
No
"Transfer module
4-168.
2-63
Previous
Next
Go Back