5026
Replace all the screws (G) from the left side of the printer, including:
d.
•
Ethernet port connector (1 screws)
Modem shield (1 screws)
•
•
Hard disk shield (2 screws)
Ground screw (1 screw)
•
Note: Be sure to attach the ground wire (H) to the ground screw.
e.
Reconnect all the cables to the system board. Use the diagram below for a guideline.
Warning: Be careful reconnecting the printhead ribbon cable (J). It can be damaged and should be
handled carefully. A flat ribbon cable can easily be damaged and should be connected gently by hand.
Install the hard disk if appropriate.
f.
Service Manual
4-142
Previous
Next
Go Back