Christie Roadster S+12K User Manual page 78

Operation
3-36
3D STEREO SYNC SELECT
Define which of the
—
Mirage 3D Stereo Sync
Cable's input connecters is
routed from your server.
Use only if the cable is
present.
3D STEREO SYNC DELAY —
reference point for synchronizing the display with your glasses. Proper adjustment of
this delay should eliminate cross talk and odd colors caused by timing differences
between the glasses and the projected display. Use this slide bar only if the Mirage
3D Stereo Sync Cable is connected between the projector's GPIO port and a server.
Slide bar values indicate the number of lines that are delayed.
This option allows the projector to control the output frame
FRAME LOCK ENABLE —
timing based on the input signal. The locked option forces (if possible) the output
image to be phase locked to the input frames. Rate Matched means that the output
runs at close to the input frequency but isn't locked to it so the output will drift in
phase relative to the output. Free Run forces the output to run at a 60Hz frame rate.
NOTE: 1) See separate Using 3D in Mirage manual provided for additional information
Mirage HD Series — Simulation 3D —
SETTINGS
Use the options in the Simulation
3D menu to make the timing
adjustments necessary for realistic
simulation and 3D images.
NOTE: For complete 3D
application notes, refer to the
separate Using 3D in Mirage
manual provided with the Mirage
projector.
FRAME DELAY MONITOR —
best results, the value should
remain fairly constant, indicating that timing of input and output frames is locked; the
Frame Delay Monitor value should stay within 5-10 lines or so of the Frame Delay
setting. If a frame is lost or "dropped", this value will cycle to maximum and jump to
minimum and then repeat, indicating that the frame input is no longer equal to the
output. If the signal is not locked, the values will change erratically; you can adjust
the Frame delay to attempt a correction.
NOTE: See separate Using 3D in Mirage manual provided for more information.
Set the number of lines delayed between the input signal and its
FRAME DELAY —
appearance on screen, keeping in mind that projector processing always adds one
frame of delay to the frame delay setting. For applications such as simulation, where
Set when the L/R frames begin, defining the best
SUBMENU OF ADVANCED IMAGE
Frame Delay Monitor
1.
Frame Delay
2. Dark Interval
3. 3D Sync Input
4. 3D Sync Output
5.
3D Stereo Sync Delay
6. Frame Lock Enable
7.
Mirage HD Models
For
Roadster & Mirage S+/HD User Manual
1. Locked
2. Rate Matched
3. Free Run
Simulation 3D
1047
1000
2500
Input A
To Emitter
592
Locked
3D Source
020-100002-04 Rev. 1 (12-2008)