Christie Roadster S+12K User Manual page 120

Maintenance
Lamp and Filter 
Replacement
Power Cord 
and Attachments
4-2
Do not place the projector on an unstable cart, stand or table. If the projector is going
to be ceiling mounted, only use the Christie-approved ceiling mount fixture designed
for your projector.
A projector and cart combination should be used with care. Sudden
stops, excessive force, and uneven surfaces may cause the projector
and cart combination to overturn.
Do not operate the Bubble lamp for more than the lamp's warranty limit; risk
LAMP:
of the lamp shattering increases as a result of changes in the quartz glass that occur
with use. Operation beyond the lamp's warranty limit also significantly reduces
brightness output.
Wait approximately five minutes after powering down the
projector to allow internal cooling fans to stop and for the lamp
to cool sufficiently before removing.
Never attempt to remove the lamp housing directly after use.
The lamp is under great pressure when hot and may explode,
causing personal injury and/or property damage. Allow cooling
The Bubble lamp operates at a very high temperature and pressure. Failure to allow
the lamp to sufficiently cool prior to handling could result in an explosion causing
personal injury and/or property damage. After turning the projector off it is important
that you wait at least five minutes before unplugging it. This provides enough time
for the internal lamp cooling fans to cool the lamp and to automatically shut off. Cool
completely before handling.
Use only lamps supplied by Christie. Use lamps of the correct
wattage for your projector model when replacing.
Replace the front filter when you replace the lamp or sooner. If this filter is
FILTER:
not replaced, airflow may become restricted and cause the projector to overheat.
See 4.4, Replacing the Lamp and Filter for the complete replacement procedure.
The North American rated line cord is provided with each projector. Ensure
that you are using a line cord that meets the appropriate rating standards.
Only use attachments or accessories recommended by Christie, such as the specific
power cord supplied. Use of other attachments or accessories with this projector may
result in the risk of fire, shock or personal injury.
WARNING
completely.
WARNING
WARNING
Use Christie approved filters ONLY.
Roadster & Mirage S+/HD User Manual
020-100002-04 Rev. 1 (12-2008)